4/3/2023 0 Comments Openzfs virtualboxYou can create any pool depending upon your storage requirements. To create a mirrored pool, run the following command in Terminal: $ sudo zpool mirror To create a striped pool, run the following command in Terminal: $ sudo zpool create Once you have decided the pool type and the drives that need to pool, the next step is to create a pool from the above set of drives using zpool command available in Linux that is used to configure storage pools in ZFS. I will use these two drives to create a storage pool. In our scenario, we have two drives available that are sdb and sdc. To find out the drives, run the following command in Terminal: $ sudo fdisk –lįrom the output of fdisk command, note down the names of the drives which should be something like sda, sdb, sdc. Now we have to identify what drives are available on our system to pool. If one drive fails, you can still access your data. In a mirrored pool, a single and complete copy of data is stored on all drive. However, If one drive fails, you will lose all your data. You can get combined storage and faster read/write speed. In a striped pool, copy of data is stored across all drives. There are two types of pool you can create: Then decide which drives to put in the storage pool. The first step while creating a ZFS storage pool is to know what type of pool you want to create. You will see the output similar to below.Īfter installation, we will create a pool of drives. To verify the installation, run the following command in Terminal: $ whereis zfs Wait for a while until the installation is completed. To install ZFS on Ubuntu 18.04 LTS, launch the Terminal by pressing Ctrl+Alt+T and then type the following command in it: $ sudo apt install zfsutils-linux We will use Ubuntu 18.04 LTS for describing the procedure mentioned in this article. Data integrity verification and automatic repair. Some of the features of ZFS are as below: But before going through the procedure, let’s take a look at its features: Features of ZFS In this article, we will show you how to install ZFS and how to set up a ZFS storage pool. ZFS storage pool can deal with a large amount of data that offers you to extend your on-site cloud solution. Now it has been ported to additional OSes including FreeBSD, Linux, and Mac OSX. It was first created at Sun Microsystems and now a part of the OpenZFS project. It allows you to store and manage a large amount of data. ZFS is a combined file system as well as a logical volume manager that offers raid like functionality with data integrity and simplified storage management.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |